Making up thespacers for the hanging knees and the aft of the cabin upright posts to fit the aft of the cabin deck beams to an d then be able to fit the carlins and cabin sides.

 https://youtu.be/NFYW0uYMlK0

Making the spacers for the hanging knees ahead of the cabin front & making up the two upright posts for the aft end of main cabin to which the short aft deck beams will be jointed into with half lap and half dovetail joints. Also I am making up the spacers to go in between the hanging knees and the deck beam ahead of the main cabin and the grown frame on the hull to make the whole area a ring frame which will tie the deck beam to the hull framing and when the rig is under tension the stress will be spread around the whole structure and not just on one part of the hull. In the meantime, I will be making up studding to bolt the frames to the hanging knees and also the deck beam to the hanging knees


Comments

Post a Comment

Popular posts from this blog

Work done today on Mai Star II

Image
Having removed the lower section of the first frame to have a lower section across the keel/hog. It is time to make a pattern of the piece and go through the oak pile to find some suitable pieces of oak to make up a new lower section which connects together  the two frames in the hull at the forward end of the keel bolts.  Another jobwe did was to remove as much of the rotten section of lower forefoot which the samson post mortised into when it was in position. The new forefoot will be made out of some of the seasoned oak  we have in the yard and will likely be made up of two pieces glued together to make up the correct thickness. and then new bolts will be made up and the fore foot will then be bedded on a bed of red lead putty and thick paint.  The three bolts were able to be moved in their holes which is a good sign and will make it easier to put new bolts in to the holes. possibly go up a size and bore new holes through the outer part of the hog/keel. Just placin...
Read more

This week has been a few highs and lows

Image
  Now that some of my day jobs are well underway, it gives me time to get the oak out of the timber pile and get it into a position where I can cut the lengths for steaming the new ribs into the boat once they are cut and planed and thickened to the correct shape and size.   However, before I can do that I will have to get the stems in the planks cleaned out so the gaps in the gaps can close up a bit when the new ribs are steamed in. However I have to clear up the yard round the boat to get to the area I have to work. 
Read more

Major progress on Mai Star II's foredeck beams and carlins and mast block and post.

Image
The apprentice boat builder Ethan as been working hard on getting the foredeck beams finished off and making up two new carlins and side deck beams/ Mai Star II needed to have replacement carlins as the old carlins were broken and rotten at the ends as were the short side deck beams which were in a poor condition. The next job to do before we can fit the new carlins and side deck beams is to make up a temporary aft cabin deck beam to go across the aft end of the cabin to fit the carlins. This is while we make up the vertical posts to fix the inboard end of the aft cabin beams.  The new mast pad fitted into the aft two deck beams as the original mast pad was, the only difference this time is that this pad will not have a hole drilled in the middle as per the original pad. This is because this time the mast which was cut down at sometime in the past will be fitted to a taberance . There will be a mast support post fitted to the underside of the deck as it was before the restoration....
Read more