Progress on Mai Star II this last week at the Boatyard

 We have now got the new port side frame screwed in position. Now that is done we can start to shore up the planks that are not sitting correctly to the shape of the frame because they have moved over the years and had refastened when they started to move. So we are going to sort this out now when we refasten this frame in to position. This will also help when it comes time to refit the ribs that are missing in the same area of the hull.


Comments

Post a Comment

Popular posts from this blog

Major progress on Mai Star II's foredeck beams and carlins and mast block and post.

Image
The apprentice boat builder Ethan as been working hard on getting the foredeck beams finished off and making up two new carlins and side deck beams/ Mai Star II needed to have replacement carlins as the old carlins were broken and rotten at the ends as were the short side deck beams which were in a poor condition. The next job to do before we can fit the new carlins and side deck beams is to make up a temporary aft cabin deck beam to go across the aft end of the cabin to fit the carlins. This is while we make up the vertical posts to fix the inboard end of the aft cabin beams.  The new mast pad fitted into the aft two deck beams as the original mast pad was, the only difference this time is that this pad will not have a hole drilled in the middle as per the original pad. This is because this time the mast which was cut down at sometime in the past will be fitted to a taberance . There will be a mast support post fitted to the underside of the deck as it was before the restoration....
Read more

Making a start on removing the last of the starboard sheer stake plank

Image
Yesterday I started to remove the last part of the starboard sheer stake plank to gain access to the back of the beam shelf/ gunwale to be able to pass the new steamed oak ribs into place after the old doubled and sistered ribs are removed. As you can see from this photo I have  uncovered a can of worms in the way of other work that is going to have to be done before any other work can be done on the sheer stake or any other part of the boat in this area. There is an area of expending foam in a void space behind the forward apron of the stem, there is a lot of checking in the breasthook and a former colony of woodworm long since gone away. So I am will have to make a new laminated breasthook and also do a repair to the upper section of stem to remove any rot that as travelled down thew stem that can not be seen from just looking at the exposed part. The copper nail on the upper part of the photo is a nail that was made up from a length of copper rod with the end pinned over to make...
Read more

It is Christmas time again, a chance to have a break and plan for the New Year.

This past year has been a busy year with trips to and from Woodplumpton to work on our other project boat Chance. Chance is now back in Essex at Titchmarsh Marina  less than a mile from my own workshop.  Before you ask why is Chance not in my yard, the answer my yard is not large enough to fit her in and so Chance is in a nearby boatyard where I can work on her between my clients boat jobs or when I have any spare time to work on her.  Now it is the time when most people put their boat restoration projects to bed until after the Christmas break. We are doing the same. Like other people we all need a break and a rest from working on our projects and the weather is not conducive to working outside in the cold weather unless you have too. Simon as done this for the past 46 years as a boat builder and this year is going to take a well earned break from working on boats over the Christmas break. We have not stopped planning what the jobs we wish to achieve on both Mai Star II ...
Read more