Remaking the lower section of the Samson Post.

After cutting the 12" scarf joint on the upper section of the samson post it was time to level up the joint to it the new sectin of samson post to the new joint 


Using a straight piece of wood removed the high spots and levelled it across the joint it was time to make up the new lower section of the samson post 


The upper section now ready to fit the lower section 


The new section made up and glued to the upper section with west epoxy resin and a lot of clamps to ensure the joint is glued together.


The cross clamps to hold the lower section in place while the gue cures off over night, the nit will be ready to shape up next week.


 

Comments

Post a Comment

Popular posts from this blog

Work done today on Mai Star II

Image
Having removed the lower section of the first frame to have a lower section across the keel/hog. It is time to make a pattern of the piece and go through the oak pile to find some suitable pieces of oak to make up a new lower section which connects together  the two frames in the hull at the forward end of the keel bolts.  Another jobwe did was to remove as much of the rotten section of lower forefoot which the samson post mortised into when it was in position. The new forefoot will be made out of some of the seasoned oak  we have in the yard and will likely be made up of two pieces glued together to make up the correct thickness. and then new bolts will be made up and the fore foot will then be bedded on a bed of red lead putty and thick paint.  The three bolts were able to be moved in their holes which is a good sign and will make it easier to put new bolts in to the holes. possibly go up a size and bore new holes through the outer part of the hog/keel. Just placin...
Read more

This week has been a few highs and lows

Image
  Now that some of my day jobs are well underway, it gives me time to get the oak out of the timber pile and get it into a position where I can cut the lengths for steaming the new ribs into the boat once they are cut and planed and thickened to the correct shape and size.   However, before I can do that I will have to get the stems in the planks cleaned out so the gaps in the gaps can close up a bit when the new ribs are steamed in. However I have to clear up the yard round the boat to get to the area I have to work. 
Read more

Major steps forward with the fitting of the original deck beams and a couple of the new deck beams.

Image
The foredeck is getting rebuild with a mixture of old and new deck beams. The forward deck beams are some of the original deck beams which have been checked over and have been cleared to be used again as they are in good condition.  The forward deck beams are being positioned where they were original fitted, however, this time they will be fixed in position with custom made bolts and not iron spikes as they were original fixed in position. The new deck beams will have to have a straight edge run through from they bow to ensure they are at the same level as the forward deck beams. Any work will be done to these to ensure this is achieved before they are all fixed in position. The whole of these deck beams will ensure the front of the hull will stay in its correct position and shape. Once the fore deck is sorted then the fore deck hatch can be fixed in position to ensure the other deck fitting go back in their original position.  
Read more